This adds support for specifying options needed to deal with phone
display panel pecularities (ex. screen curves, notches, punch holes)
This is implemented as settings in ~/.config/plasmamobilerc, which can
set panel heights, paddings, and center spacings to duck display
cutouts. The pixel values are scaling independent, and so are not
affected when the display scaling is changed.
This is then exposed over DBus, so that components from outside of
plasmashell (ex. KWin) can access it easily without needing to connect to
kscreen themselves. Each screen is exposed as a single object.
Currently support is only added in the status bar and the navigation
panel.
Currently all screens have the settings applied. In the future, we may
want to limit this just to the internal screen (?)
---
This also adds a "devices" folder (in `devices/configs`) where per-device configs can be set.
This is installed to `/usr/share/plasma-mobile-device-configs`.
In `plasmamobilerc` (installed to `/etc/xdg/plasmamobilerc`, or
`~/.config/plasmamobilerc`), envmanager will read:
```toml
[Device]
device=oneplus-enchilada
```
for the device config to use and write its settings to
`~/.config/plasma-mobile/plasmamobilerc`.
When the device is rotated and autorotate is off, a button will appear
on the navigation panel to manually rotate.
This is specific to the navigation panel, perhaps we can have a floating
button in gesture-only mode similar to Android?
TODO: PoC, I haven't yet actually tested this on device. I also need to
make sure that I check for whether autorotation is enabled on the
output.
Move from a C++ library + QML plugin to a QML plugin only for simplicity, since the homescreen switching architecture will be done from Plasma, and so use of the shell library only needs to be from QML.
